Fortinet FortiGate-800 User Manual download pdf (Page 264)

264 Fortinet Inc.

Configuring L2TP PPTP and L2TP VPN

Figure 65: Sample L2TP address range configuration

To add source addresses

Add a source address for every address in the L2TP address range.

1 Go to Firewall > Address.

2 Select the interface to which L2TP clients connect.

This can be an interface, VLAN subinterface, or zone.

3 Select New to add an address.

1 Enter the Address Name, IP Address, and NetMask for an address in the L2TP

address range.

2 Select OK to save the source address.

3 Repeat for all addresses in the L2TP address range.

To add a source address group

Organize the source addresses into an address group.

1 Go to Firewall > Address > Group.

2 Add a new address group to the interface to which L2TP clients connect.

This can be an interface, VLAN subinterface, or zone.

3 Enter a Group Name to identify the address group.

The name can contain numbers (0-9), uppercase and lowercase letters (A-Z, a-z), and

the special characters - and _. Other special characters and spaces are not allowed.

4 To add addresses to the address group, select an address from the Available

Addresses list and select the right arrow to add it to the Members list.

5 To remove addresses from the address group, select an address from the Members

list and select the left arrow to remove it from the group.

Note: If the L2TP address range is comprised of an entire subnet, add an address for this

subnet. Do not add an address group.

1 2 ... 259 260 261 262 263 264 265 266 267 268 269 ... 335 336

No comments

Fortinet FortiGate-800 User Manual Page 264