Fortinet FortiGate-800 User Manual download pdf (Page 268)

268 Fortinet Inc.

Configuring L2TP PPTP and L2TP VPN

To disable IPSec

1 Select the Networking tab.

2 Select Internet Protocol (TCP/IP) properties.

3 Double-click the Advanced tab.

4 Go to the Options tab and select IP security properties.

5 Make sure that Do not use IPSEC is selected.

6 Select OK and close the connection properties window.

7 Use the registry editor (regedit) to locate the following key in the registry:

HKEY_LOCAL_MACHINE\System\CurrentControlSet\Services\Rasman\

Parameters

8 Add the following registry value to this key:

Value Name: ProhibitIpSec

Data Type: REG_DWORD

Value: 1

9 Save the changes and restart the computer for the changes to take effect.

You must add the ProhibitIpSec registry value to each Windows XP-based

endpoint computer of an L2TP or IPSec connection to prevent the automatic filter for

L2TP and IPSec traffic from being created. When the ProhibitIpSec registry value

is set to 1, your Windows XP-based computer does not create the automatic filter that

uses CA authentication. Instead, it checks for a local or active directory IPSec policy.

To connect to the L2TP VPN

1 Connect to your ISP.

2 Start the VPN connection that you configured in the previous procedure.

3 Enter your L2TP VPN User Name and Password.

4 Select Connect.

5 In the connect window, enter the User Name and Password that you use to connect to

your dialup network connection.

This user name and password is not the same as your VPN user name and password.

Note: The default Windows XP L2TP traffic policy does not allow L2TP traffic without IPSec

encryption. You can disable default behavior by editing the Windows XP Registry as described

in the following steps. See the Microsoft documentation for editing the Windows Registry.

1 2 ... 263 264 265 266 267 268 269 270 271 272 273 ... 335 336

No comments

Fortinet FortiGate-800 User Manual Page 268