Fortinet FortiGate 4000 User Manual download pdf (Page 145)

Network configuration Configuring interfaces

FortiGate-4000 Installation and Configuration Guide 145

4 Clear the Retrieve default gateway and DNS from server check box if you do not want

the FortiGate unit to obtain a default gateway IP address and DNS server IP

addresses from the DHCP server.

By default, this option is enabled.

5 Clear the Connect to Server check box if you do not want the FortiGate unit to connect

to the DHCP server.

By default, this option is enabled.

6 Select Apply.

The FortiGate unit attempts to contact the DHCP server from the interface to set the

IP address, netmask, default gateway IP address, and DNS server IP addresses.

7 Select Status to refresh the addressing mode status message.

8 Select OK.

Configuring an interface for PPPoE

Use the following procedure to configure any FortiGate interface to use PPPoE.

If you configure the interface to use PPPoE, the FortiGate unit automatically

broadcasts a PPPoE request. You can disable connect to server if you are configuring

the FortiGate unit offline and you do not want the FortiGate unit to send the PPPoE

request.

By default, the FortiGate unit also retrieves a default gateway IP address and DNS

server IP addresses from the PPPoE server. You can disable the option Retrieve

default gateway and DNS from server if you do not want the PPPoE server to

configure these FortiGate settings.

To configure an interface for PPPoE

1 Go to System > Network > Interface.

2 Choose an interface and select Modify .

3 In the Addressing Mode section, select PPPoE.

4 Enter your PPPoE account User Name and Password.

5 Clear the Retrieve default gateway and DNS from server check box if you do not want

the FortiGate unit to obtain a default gateway IP address and DNS server IP

addresses from the PPPoE server.

By default, this option is enabled.

6 Clear the Connect to Server check box if you do not want the FortiGate unit to connect

to the PPPoE server.

By default, this option is enabled.

initializing No activity

connecting The FortiGate unit is attempting to connect to the DHCP server.

connected The FortiGate unit retrieves an IP address, netmask, and other settings from

the DHCP server.

failed The FortiGate unit was unable to retrieve an IP address and other

information from the DHCP server.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 331 332

No comments

Fortinet FortiGate 4000 User Manual Page 145