Fortinet FortiGate 4000 User Manual download pdf (Page 40)

40 Fortinet Inc.

Turning FortiGate-4000 chassis power on and off Getting started

Out of band management connections

You can manage the FortiBlade-4010 modules by connecting to the 10/100 out of

band management module. The 10/100 out of band management module provides

ethernet management connections for all of the FortiBlade-4010 modules installed in

the FortiGate-4000 chassis. See Figure 6 on page 31 or Figure 7 on page 32 for the

location of the 10/100 out of band management module.

Console management connections

You can connect to the CLI of each FortiBlade-4010 module by connecting the RJ-45

to DB-9 serial cable to the management module console port (see Figure 10 on

page 33). The management module provides console connections for all of the

FortiBlade-4010 modules installed in the FortiGate-4000 chassis.

Use the KVM switch module to switch serial connections to the CLI of each

FortiBlade-4010 module installed in the FortiGate-4000 chassis. To access the CLI,

connect the black header of the RJ-45 to DB-9 serial cable to the management

module (see “Management module” on page 33) and to a management PC. You can

use the KVM switch module (see “KVM switch module” on page 30) to select the

FortiBlade-4010 module that you can connect to.

Turning FortiGate-4000 chassis power on and off

Use the following procedures when turning on and off power to the FortiGate-4000

chassis. Turn power on and power off in the order specified in the following

procedures to avoid damaging FortiGate-4000 chassis components.

• Turning on FortiGate-4000 chassis power

• Turning off FortiGate-4000 chassis power

The FortiGate-4000 chassis automatically recovers from a power outage. When the

power restores, the FortiGate-4000 chassis takes a few seconds to power on. A few

seconds after the chassis is on, the FortiBlade-4010 modules power on automatically.

Turning on FortiGate-4000 chassis power

Turning on the FortiGate-4000 chassis power consists of making power connections,

turning on power supplies, and then turning on individual components.

1 Make sure all FortiGate-4000 chassis power switches are turned off.

Check the following:

• Power switch on each power supply module

• Chassis power switch on the power connector module

• On/off switch on the management module

• On/off switch on the switched interface module (FortiGate-4000S)

Note: All FortiBlade-4010 modules are shipped with the same default IP address (172.16.1.2).

You need to change the IP address before trying to manage the modules.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 331 332

No comments

Fortinet FortiGate 4000 User Manual Page 40