Fortinet FortiGate 4000 User Manual download pdf (Page 43)

Getting started Hot swapping modules

FortiGate-4000 Installation and Configuration Guide 43

7 Slide the power supply module into the slot until the lock clicks into place.

8 Turn on the power supply.

9 Replace the locking strip.

10 Quickly toggle the chassis power supply switch to turn on the power supply module.

Hot swapping interface modules

This procedure describes how to hot swap a pass-through interface module or a

switched interface module.

For more information on these modules, see “Pass-through interface module” on

page 35 and “Switched interface module” on page 35 respectively.

1 From the rear panel of the FortiGate-4000 chassis, loosen the two mounting knots that

fasten the pass-through interface module or the switched interface module that you

want to replace. Do not remove the mounting knots.

2 Do one of the following:

• For the pass-through interface module, pull it out.

• For the switched interface module, turn its power off and then pull it out.

3 Do one of the following:

• Insert the new pass-through interface module into the chassis.

• Insert the new switched interface module into the chassis, and turn on its power.

4 Tighten the mounting knots on the pass-through interface module or the switched

interface module.

Hot swapping the 10/100 out of band management module

Follow this procedure to hot swap a 10/100 out of band management module on the

rear panel of the FortiGate-4000 chassis.

For more information, see “10/100 out of band management module” on page 34.

1 From the rear panel of the FortiGate-4000 chassis, loosen the two mounting knots that

fasten the 10/100 out of band management that you want to replace. Do not remove

the mounting knots.

2 Pull the module out.

3 Insert the new switched interface module into the chassis.

4 Tighten the mounting knots on the module.

Hot swapping the management module

Follow this procedure to hot swap a management module on the rear panel of the

FortiGate-4000 chassis.

For more information on these modules, see “Management module” on page 33.

1 Power off the management module that you want to replace.

Note: If you press the chassis power supply switch for more than four seconds, the entire

FortiGate-4000 unit turns off.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 331 332

No comments

Fortinet FortiGate 4000 User Manual Page 43